Camera
stand.
A place for your phone.
A better angle on your work.
A printable table-clamp mount with nine tilt positions and room for a charging cable. This styled edition refines the outline of the original build.
Make it yours.
Print the supplied parts or adapt the CAD to your setup.
Before you print.
Five printed parts and two steel pins bring the stand together.
- PLA, designed without supports. A 3MF plate includes the part orientations; choose settings for your printer and filament.
- Hardware
- 2 mm steel rod, cut to 44 mm and 28.8 mm. Allow 75 mm of stock for cutting and finishing.
- Fit
- Designed around an iPhone 16 measuring about 14 mm thick including its case and a ¾-inch (19.05 mm) tabletop. Adapt the STEP file for other sizes.
The styled edition is supplied for printing and refinement. Its print fit has not yet been verified; socket and thread clearances may need tuning.
Bring it together.
The guide walks through each part, pin and fit check. Print it at 100% to use the true-size sorting card.
Open assembly guide